Sometimes when you're making changes within Open Firmware things don't always go right, and you end up bricking your computer. This is often evident when you boot up and then hear the boot chime, and then it restarts resulting in a boot loop. Otherwise it may not boot at all.
 
You can reset Open Firmware's default settings by performing the following, based on your computer:
 
Desktops
With your computer off, press and keep holding the power button. You hear the programmers tone (not the boot chime), but keep holding. Next you will hear a boot chime and then the system will enter Open Firmware with the default settings loaded.
 
Portables
With your computer off, press and keep holding power and the Command/Apple Key. You will hear the programmers tone, but keep holding. Next you will hear the boot chime and the system will enter Open Firmware with the default settings loaded.
 
Once your computer has booted into Open Firmware you should run the following commands to reset the NVRAM contents, and any other misconfigured settings:
reset-nvram
set-defaults
reset-all

 

This Information was sourced from darthnVader on macos9lives.com